Carburetors assembling. Part 1. >> With gaskets issue being solved, installation of float bowls was only a matter of five minutes. For float bowls I chose stainless steel Allen bolts with cylindrical heads. New fuel…
Read more
Carburetors were ready for assembling, however I have a couple of other works to attend to, thus I placed parts of my Mikuni VM24 carburetors onto the shelves and smaller of them I put in…
Read more
Dunno who was this funny fellow and what he was doing in my garage, but it was nice to have him for a company this evening, even if he occupied Kawasaki KZ650 clutch cover I…
Read more
Creating exploded views like this one with Kawasaki KZ650 carburetors is quite complicated task. One have to think out parts positioning, do not forget any part or piece of hardware and then lay all parts…
Read more
Carburetors have come a long way of “evolution” since they were invented and in time they became quite complicated. It’s quite a lot of work to adjust carburetor to work perfectly in all range of…
Read more
One may wonder why so far there was only one October post. For one thing for about two weeks I didn’t work on KZ650 project, but was preparing my garage to upcoming winter. I made…
Read more
Remember this nice KZ750 cylinder head that made long way to me from USA through Germany? I cleaned it, I checked all I could, I found out that two from four exhaust valves were slightly…
Read more
Kawasaki KZ650 as well as KZ750 has 12 cylinder studs with M10 thread of following lengths: 4 studs x 153mm (part number 92004-062), 4 studs x 133mm (92004-1004) and 4 studs x 116mm (92004-1007). The …
Read more
So, what should have happened in June happened only in September. Yesterday I finally finished rear wheel. I placed second order for Excel 18″ 2.5″ high shouldered rim as soon as I became sure that …
Read more
