SRX600

Engine was installed in frame but there were a lot of works to do before it could start. Firstly I worked on oil system. I cleaned oil tank inside and outside, then straightened bent oil…
Read more

But as I earlier mentioned, it is always work to be done in my garage. So while I waited for delivery of parts from missed parcel which I re-ordered, I have done a lot of…
Read more

At the end of May 2013 crankshaft was renovated. Cylinder was bored and honed. I also ported cylinder head channels a little due to “baked caramel” removing. Efforts I applied were worth them all, channels…
Read more

So I put engine on workbench and began disassembling it in February 2013 . There was nothing worrying at first glance. Camshaft was in good shape, without signs of oil starvation. Carbon depositions persisted in…
Read more

I do not only customize bikes, as might attentive reader notice. I repair and restore some motorcycles also. I did that more frequently earlier but now I take only interesting bikes in work. This story…
Read more